Research Article
Open access
Published on 25 May 2023
Download pdf
Cao,Y. (2023). Research on the Influence of Airfoil on the Flying Performance of Glider. Theoretical and Natural Science,5,343-347.
Export citation

Research on the Influence of Airfoil on the Flying Performance of Glider

Yingqi Cao *,1,
  • 1 Leicester International Institute, Dalian University of Technology, Panjin, Liaoning, Province, China, 124000

* Author to whom correspondence should be addressed.

https://doi.org/10.54254/2753-8818/5/20230580

Abstract

Gliders are heavier-than-air fixed-wing aircraft that do not rely on power plants to fly, and are now widely used in scientific observation, daily entertainment, and other fields. After taking off, it only relies on the reaction force of air acting on its lifting surface for free flight. Different gliders can stay in the air for different amounts of time in different environments, which is mainly determined by the airfoil. Therefore, through literature reading, this paper understands its flight principle, and studies and analyzes the advantages and disadvantages of existing airfoils by comparing the influence of different airfoils on flight performance. In view of the problems existing in the airfoil, rationality calculations and improvements are put forward, hoping to promote the development of the aviation industry. After research, the concave wing is by far the most suitable gliding airfoil, which can provide relatively large lift and stability, but there is still the problem of insufficient load. In order to improve these deficiencies, the airfoil is optimized by increasing the contact area between the airflow and the wing. For example, the defect can be improved by lengthening the length of the entire wing, reducing lateral airflow, and increasing the upward curvature of the wingtip.

Keywords

glider, airfoil, Glide stability, aerodynamics, Bernoulli's Principle.

[1]. Azuma, A. (1992). Flight By Gliding. In: The Biokinetics of Flying and Swimming. Springer, Tokyo. https://doi.org/10.1007/978-4-431-68210-3_3.

[2]. Horvath, J., Cameron, R. (2016). Airfoils. In: 3D Printed Science Projects. Apress, Berkeley, CA. https://doi.org/10.1007/978-1-4842-1323-0_4

[3]. Peiqing Liu. (2022). Aerodynamics. Springer Singapore. https://doi.org/10.1007/978-981-19-4586-1.

[4]. Kravets, V.V., Shvets, A.I.(1983). Separation flows on a concave conical wing. Fluid Dyn 18, 235–242 . https://doi.org/10.1007/BF01091111.

[5]. Isaev, S.A., Sudakov, A.G., Usachov, A.E. (2015). et al. Modeling an increase in the lift and aerodynamic efficiency of a thick Göttingen airfoil with optimum arrangement. Tech. Phys. Lett. 41, 561–564 . https://doi.org/10.1134/S1063785015060061.

[6]. Bai, Xr., Cheng, Hy., Ji, B. et al. (2020). Spatial and spectral investigation of turbulent kinetic energy in cavitating flow generated by Clark-Y hydrofoil. J Hydrodyn 32, 175–178. https://doi.org/10.1007/s42241-020-0009-1.

[7]. Zhao, L., Wang, P., Sun, Cy. et al.(2019). Modeling and Motion Simulation for A Flying-Wing Underwater Glider with A Symmetrical Airfoil. China Ocean Eng 33, 322–332. https://doi.org/10.1007/s13344-019-0031-7.

[8]. Deng, Q., Gursul, I. (1997). Vortex breakdown over a delta wing with oscillating leading edge flaps. Experiments in Fluids 23, 347–352 . https://doi.org/10.1007/s003480050121.

[9]. Gallais, P. (2007). Aerodynamics. In: Atmospheric Re-Entry Vehicle Mechanics. Springer, Berlin, Heidelberg. https://doi.org/10.1007/978-3-540-73647-9_4.

[10]. Leloudas, S.N., Eskantar, A.I., Lygidakis, G.N. et al. (2020). Low Reynolds airfoil family for small horizontal axis wind turbines based on RG15 airfoil. SN Appl. Sci. 2, 371. https://doi.org/10.1007/s42452-020-2161-1.

[11]. Gao, L. (2022). Wind Tunnel Test. In: Cui, W., Fu, S., Hu, Z. (eds) Encyclopedia of Ocean Engineering. Springer, Singapore. https://doi.org/10.1007/978-981-10-6946-8_265.

Cite this article

Cao,Y. (2023). Research on the Influence of Airfoil on the Flying Performance of Glider. Theoretical and Natural Science,5,343-347.

Data availability

The datasets used and/or analyzed during the current study will be available from the authors upon reasonable request.

Disclaimer/Publisher's Note

The statements, opinions and data contained in all publications are solely those of the individual author(s) and contributor(s) and not of EWA Publishing and/or the editor(s). EWA Publishing and/or the editor(s) disclaim responsibility for any injury to people or property resulting from any ideas, methods, instructions or products referred to in the content.

About volume

Volume title: Proceedings of the 2nd International Conference on Computing Innovation and Applied Physics (CONF-CIAP 2023)

Conference website: https://www.confciap.org/
ISBN:978-1-915371-53-9(Print) / 978-1-915371-54-6(Online)
Conference date: 25 March 2023
Editor:Marwan Omar, Roman Bauer
Series: Theoretical and Natural Science
Volume number: Vol.5
ISSN:2753-8818(Print) / 2753-8826(Online)

© 2024 by the author(s). Licensee EWA Publishing, Oxford, UK. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license. Authors who publish this series agree to the following terms:
1. Authors retain copyright and grant the series right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this series.
2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the series's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this series.
3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See Open access policy for details).